The Power of Three: A Solder Mask Solution for North America


Reading time ( words)

Technology and process developments in mature industries like the printed wiring board industry are not always easy. Many new products are evolutionary enhancements of existing processes. Often, these developments enhance the process and improve overall process control.

The concept for direct digital imaging, as an example, has been around for some time, beginning in the early 1980s. Early pioneers were Excellon Automation and Eocom, in Orange County. At that time the industry was entrenched with dry film photo imaging and, at least in the North American market, there was little interest in pioneering a concept as revolutionary as direct imaging along with its attendant issues of cleanrooms and other environmental aspects. Dry film was viewed as a more robust application. Market adoption of liquid resist was also tempered by the high cost of the liquid material versus dry film.

Often, the equipment provider has a visionary leader who brings technology changes forward, but the collaboration between the equipment provider and the consumable supplier is often not a close one, or it’s nonexistent.

As digital technology started to penetrate other applications, for example, digital cameras, the vision of lowering costs and improving image quality began to take hold. But the equipment was, and still is, very expensive and requires high-cost service contracts. Nonetheless, fabricator after fabricator began embracing the newer product offerings for primary imaging, but not solder mask, which was an entirely different requirement.

Taiyo, as the leading supplier of liquid solder mask products in North America, also had a visionary concept moving forward. During IPC APEX EXPO 2016, executives from Taiyo and Schmoll sat together and worked out a testing plan that Taiyo would implement to develop a solder mask product that met the North American marketplace needs.

Schmoll provided the equipment for the testing and development, Taiyo the development protocol, and Burkle North America the installation and maintenance expertise. The result is a solder mask product and process that is being introduced during IPC APEX EXPO 2017.

 

Editor's Note: This article originally appeared in the February 2017 issue of The PCB Magazine.

 

 

Share

Print


Suggested Items

New High-speed 3D Surface Imaging Technology in Electronics Manufacturing Applications

10/09/2019 | Juha Saily, Focalspec Inc.
Line confocal sensors—and scanners based on them—are used in the imaging of surfaces, transparent materials, and multi-layered structures in various metrology and inspection applications on discrete parts, assemblies, webs, and other continuous products. Line confocal sensors operate at high speed and can be used to scan fast-moving surfaces in real-time as well as stationary product samples in the laboratory.

Communication, Part 1: How to Qualify a Board Shop

10/04/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 1 of this six-part series for "Fab Fridays," Mark Thompson, CID+, engineering support at Prototron, and CA Design CTO Bob Chandler discuss ways that PCB fabricators and designers can better communicate, starting with how to qualify a board shop.

The Institute of Circuit Technology Autumn Seminar

10/03/2019 | Pete Starkey, I-Connect007
Meriden has been established as a popular Midlands venue for Institute of Circuit Technology (ICT) meetings. On September 19, a multitude of Fellows, Members, and Associates gathered for the Institute’s autumn seminar, which was organised and hosted by ICT Technical Director Bill Wilkie. The agenda included five informative technical presentations, describing current research and development on significant topics relevant to the industry.



Copyright © 2019 I-Connect007. All rights reserved.