Autocatalytic Gold: How it Fits as a Final Finish


Reading time ( words)

Introduction

Thick gold was originally requested as the solution for making gold wire bonding possible for the electroless nickel/immersion gold (ENIG) process without electroless palladium. This avoided requalification and the risks associated with a new process in a conservative industry. This trend is now being championed by the automotive industry to ensure highest reliability within the gold wire bonding and soldering arena when employing the electroless nickel/electroless palladium/immersion gold (ENEPIG) process.

Thick gold is typically considered to be in the region of 100 nm and, as such, tends to exacerbate some of the issues attributed to the current state-of-the-art immersion gold chemistry at thicknesses of 70 nm. The plating characteristics of the established immersion gold processes are not wholly compatible with thick gold deposit requirements. The reason for the incompatibility is corrosion derived from the long exposure times that are necessary to achieve thick deposits. It must be stressed that thick gold is not always achievable with immersion gold systems. This is especially true if palladium is used as a wire bonding enhancer.

Fig1.jpgIn an immersion process the deposition rate will decrease over time as the deposition layer increases in thickness and density because the availability of electron exchange is reduced. In more extreme cases the source electrons can be limited to relatively small areas of weakness in the underlying deposit and cause exaggerated corrosion events. This can be improved or overcome by employing an autocatalytic type of electroless gold plating system (Figure 1).

To read the full version of this article which appeared in the June 2018 issue of PCB007 Magazine, click here.

Share


Suggested Items

Welcome to the Silicon Valley Neighborhood: Nano Dimension Arrives in California

07/26/2018 | Dan Feinberg, Technology Editor, I-Connect007
I-Connect007 Technical Editor Dan Feinberg accepted an invitation recently to tour Nano Dimension’s new USA headquarters in Santa Clara’s Silicon Valley, which included a sit-down with President and Co-Founder Simon Fried.

EIPC 50th Anniversary Conference Day 1: The Past, the Present and the Future, Pt. 2

07/04/2018 | Pete Starkey, I-Connect007
Part 2 of I-Connect007 Technical Editor Pete Starkey's article on the recent EIPC 50th Anniversary Conference in Dusseldorf, Germany, continues with recap of technical presentations by Emma Hudson, Shannon Juan, Alex Ippich, and Russell Morgan. Read on.

The Institute of Circuit Technology Annual Symposium 2018

06/18/2018 | Pete Starkey, I-Connect007
ICT technical director Bill Wilkie is well-known for choosing notable venues for Institute of Circuit Technology events, and his choice for this year’s Annual Symposium was the National Motor Museum, located in the village of Beaulieu in the heart of the New Forest, a national park in the county of Hampshire in Southern England. The region is known for its heathland, forest trails and native ponies.



Copyright © 2018 I-Connect007. All rights reserved.