Graphite-based Direct Metallization for Fabrication of Complex Interconnect Designs

Reading time ( words)

Introduction

The technology trends are unmistakable, such as the need to move into higher functionality while reducing footprint of the PWB substrate. In turn, this triggers circuit designs with smaller vias, blind, buried and stacked vias, as well as any-layer technology. In addition, there is a call-out for more flexible and rigid-flexible printed circuit boards. Complicating matters for the fabricator is the proliferation of material sets designed to support the low-loss, high-frequency market segment. With all of these changes, along with heightened emphasis on end-product reliability and productivity, metallization performance is under the highest scrutiny. 

Direct Metallization

Direct metallization of boards is a predominant process in flex circuit and microvia manufacture. This conveyorized process is fast and efficient. However, in North America, direct metallization is not as common as in overseas marketplaces, most likely reflecting the higher percentage of flex and microvia in the production mix. Regardless, direct metallization processes (most) offer lower consumption of resources over conventional electroless copper. This includes reduced rinse water and waste treatment concerns, lower power consumption as well as fewer chemical processes to maintain. For most direct metallization systems including graphite based processes, the equipment footprint is quite small when compared to a conventional electroless copper line of equal productivity. This is indeed an advantage with respect to capex utilization and return on assets.

Read the full article here.


Editor's Note: This article originally appeared in the May 2014 issue of The PCB Magazine.

05/23/2023 | Barry Matties and Nolan Johnson, I-Connect007

Every industry has a beginning, and we are lucky to have Rex Rozario here to share the story of how the printed circuit board industry got its start. I-Connect007 chatted with Rex recently about how he became involved with circuit board inventor Dr. Paul Eisler.

05/17/2023 | Andy Shaughnessy, Design007 Magazine

At the SMTA Atlanta Expo and Tech Forum, I spoke with NCAB Group Field Application Engineer Ramon Roche, who gave a presentation at the show titled, “Technical Trends in the Global PCB Industry.” Ramon and I discussed his presentation, the emerging technologies that have NCAB’s focus over the next few years, and why semi-additive processes may be the key to succeeding with ultra HDI technology.

05/10/2023 | Pete Starkey, I-Connect007

It’s been a little while since I first had the opportunity to review an EIPC Technical Snapshot webinar. This excellent series began in October 2020 when our industry was besieged by the COVID-19 pandemic. It has continued successfully as restrictions have lifted and provides an effective channel for the efficient sharing of relevant knowledge that complements the traditional live conferences. The 20th in the series, in December 2022, focused on environmental issues impacting the electronics industry. In early February, EIPC held its live Winter Conference in Lyon and now, by popular demand, the 21st Technical Snapshot fills a slot before the Summer Conference scheduled for mid-June in Munich.